Schleuniger EcoCut 3300, Справочное руководство

Страница: 60 / 108

11. Maintenance / maintenance schedule
60|108
Reference Manual |Edition 4.0 (10-2013) |EcoCut 3300
11.4
MAINTENANCE SCHEDULE
11.4.1
General
The development and construction of the machine is focused on a minimal maintenance effort. Mainte-
nance work is mainly constricted on cleaning and lubricating certain components and removing dust and
debris. The listed maintenance intervals however can vary depending on the type of material produced
and the environmental conditions.
It is important that the system is checked periodically to find out about the grade of dirt and abrasion.
11.4.2
Maintenance chart
Maintenance work must be accomplished according to the instructions and the time intervals listed. Gen-
erally proceed according to the following chart:
Component Activity Interval Reference
(Page)
Time con-
sumed
(Min.)
Housing clean weekly 61 5
Processing area clean weekly 61 5
Blade Check/clean every 6 month 66 5
Feed rollers Check/clean every 6 month 70 5
11.5
CIRCUIT DIAGRAMS, DRAWINGS, SPARE PART LISTS
See chapter "14.4 Block diagram (Page 91)".
Document „Parts Catalog“ .
11.6
SPECIFICATION OF SPARE PARTS
See document „Parts Catalog“ .
11.7
GENERAL MAINTENANCE WORK
The cleaning interval depends on the type of material processed and the intensity of the application. The
blade area, the wire/cable guides should be held free of waste material in order to ensure precise strip-
ping results. Dirt and talcum residues may affect the functioning of the machine. The machine has to be
checked and necessarily be cleaned.
WARNING
Electric current!
Before cleaning always switch off the main switch and unplug the product from
the mains. Disregarding may lead to serious injury or death.