Schleuniger CCM 1200, Руководство по эксплуатации

Страница: 40 / 51

40 Schleuniger CCM 1200
Replacing the bottom blade
Switch the master switch off. Remove the mains plug from the power supply. The
following work should only be carried out by specially trained personnel (Schleuniger
representatives, the user’s trained specialist personnel).
•
Remove the cover together with
the ejector shaft (Figure 12, Page
37).
•
Remove the bottom blade together
with the wedge (three M6 bolts with
nuts) and clean the inside using a
paintbrush and a vacuum cleaner
attachment (Figure 17).
•
Slightly oil the wedge and new or
the resharpened blade and fit back
both components.
•
Move the wedge together with the
pin fully to the left and very slightly
tighten the screws.
•
Press the bottom blade against the
holder using a finger and slide the
wedge as far as possible to the
right (Figure 18, Page 41).
It is vital that you also read the
test for Figure 19, Page 41!!
Figure 17. Replacing the bottom blade
•
Tighten the nuts.
•
Move the upper blade up and down. The blades should just touch but not jam.
•
Now carry out a manual cut on thin strips of paper across the whole width of the blade. The cut
should always be even and sharp. If necessary, repeat the alignment procedure until the
required cutting quality is achieved.
•
Fit back the cover.
•
Insert the mains plug into the power supply.
+
The blades may produce a poor cut in the middle. You can solve this problem using the
socket head screw in the middle of the upper blade (Figure 18, Page 41):
•
If the paper is only jammed in the middle of the blade and not cut then tighten the
socket head screw slightly.
•
If the blade jams in the middle then loosen the socket head screw slightly.
connector rod
upper blade
Wedge with pin
bottom blade
Bolts bottom
blade