Form 55005 Rev. B
09-25-2001
3
CM5500 COMPUTER MANAGED MORTISE LOCK
INSTALLATION MANUAL
2. INSTALL CYLINDER, GASKET AND STANDOFFS:
A. Install cam onto cylinder. Cam can be either a cloverleaf (shown) or straight, 11/16” design (not shown).
B. Insert standard, 1-1/4” mortise cylinder into outside escutcheon from front (keypad/reader) side with keyway down.
C. Slide lock washer into place with tab on top facing out, as shown below.
D. Using nut tool (provided) tighten nut onto cylinder.
E. Line up nearest notch on nut with tab on lock washer and bend tab into notch using nut tool so nut is secure.
F. Install exterior gasket (if used).
G. Install upper and lower standoffs.
CYLINDER
RECOMMENDED CAM:
SCHLAGE P/N B502-948
NUT TOOL
EXTERIOR GASKET
LOCK WASHER
NUT
STANDOFFS
-
UPPER
STANDOFFS
-
LOWER
TAB
