Schiller BOBCAT XRZ FR651V KAW, Руководство оператора

Страница: 32 / 66

30
XRZ
ADJUSTMENTS
DECK LEVELING
1. Park the machine on a smooth, level surface.
Raise the deck to the transport position.
2. Lower the deck onto a set of equal height blocks
under the rear corners of the deck. Place an-
other set of blocks under the front of the deck so
that the deck top is pitched forward 1/8".
3. Measure the height of the blade cutting edge
above the ground. Remove pin A and set the pin
in the corresponding position to that height
4. Loosen nuts on bolts G . Move bolts in slot to
help position deck. Tighten nuts on bolts G .
DECK ROLLERS
The deck rollers are adjustable up and down to
provide improved deck flotation and scalping protec -
tion at various heights of cut. They are not intended
to ride continuously on the ground. Adjust no closer
than 3/8" (10mm) to the ground.
Height of cut ranges for roller adjustment
HEIGHT OF CUT
The height of cut is set by moving height of cut pin A
to the hole designated for the height of cut desired.
To change the height of cut:
1. Lift the deck to the highest position using the foot
lift pedal.
2. Move pin
A
to the selected hole.
3. Lower the deck until the latch lever
E
is stopped
by the pin.
NOTES
:
– Height of cut may vary due to the amount of
tread on the tires, tire diameter or inflation pres -
sure.
– For best results, adjust the rear deck rollers for
the height of cut to be used (see below).
A 1/8" forward pitched deck provides the best horsepower.
A level deck provides the best quality of cut.
A 1/8" rearward pitched deck provides the best striping.
Certain grass types and conditions may vary.