Schick QUBE II, Инструкция по эксплуатации

Страница: 57 / 130

Operating software 8
D21518 Edition 2017/07 Original Instructions
23/32
 Set the desired speed via the wheel on the control satellite
 Start the handpiece via the
o
button.
You must observe the maximum permissible speed of the clamped tool be-
fore starting the handpiece!
Maximum speed limitation
If a speed is set via the wheel on the control satellite, this cannot be overridden with the
operating elements (foot lever or knee plate). The speed is controlled dynamically with the
control element, up to the speed set.
To use a speed range between 200 and 1000 rpm, the maximum speed must be
limited to 1,000 rpm on the operating unit.
A flashing speed symbol indicates that the motor is stopped. Once the motor
is running, the speed symbol is lit continuously.
Speed control function
The speed control function allows you to operate the
motor handpiece without having to continuously ac-
tuate the operating element (knee plate, foot lever or
dynamic foot control).
Activating cruise control:
 Press the key once. The symbol appears on the display.
 Once the speed is steadily held via the control element for more than two seconds,
the control element can be released and the handpiece will continue to run with the
last used speed. To stop the handpiece, briefly actuate the control element once.