Scheppach PL55, Оригинальное руководство пользователя

Страница: 20 / 60

20
Trouble shooting
Problem Possible Cause Help
The motor does not run. Faulty motor, power supply cable or plug.
Burned out fuses.
Have the machine checked by skilled person-
nel. Do not try to repair the machine yourselves
as it may be dangerous. Check the fuses and
replace them if necessary.
The motor starts slowly
and does not reach run-
ning speed. Low power supply voltage. Damaged windings.
Burned out capacitor. Ask for the Electricity Board to check the
voltage available. Have the machine motor
checked by skilled personnel. Have the capaci-
tor replaced by skilled personnel.
Excessive motor noise. Damaged windings. Faulty motor. Have the motor checked by skilled personnel.
The motor does not
reach full power. Overloaded circuit due to lighting, utilities or
other motors. Do not use other utilities or motors on the cir-
cuit to which the plunge cut saw is connected.
Motor overheats easily Overload of the motor; inadequate cooling of
the motor Prevent overloading the motor when cutting;
remove dust from the motor to ensure an opti-
mum cooling of the motor
Decrease in cutting
power when sawing The saw blade is too small (sharpened too
often) Re-adjust the end stop of the saw unit
The saw cut is rough or
wavy The saw blade is dull; the tooth shape is not
suited to the thickness of the material Re-sharpen the saw blade or use an appropri-
ate saw blade
The work piece rips or
splinters The cutting pressure is excessive or the saw
blade is not suited to the application Use the correct saw blade