www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
27
GB
• Never store petrol near a source of sparks. Always use a tested canister. Keep petrol away from children.
• Replace defective silencers.
•
Open the petrol cap and fill the petrol tank with petrol up to the lower point of the tank filler neck.
•
Use a funnel and measuring container for filling. Do not overfill the tank.
• Only use fresh, clean, unleaded fuel.
• Never mix oil with petrol.
• Purchase fuel in quantities that can be used within 30 days to ensure that the fuel is fresh.
Attention: Use standard unleaded petrol with max. 5% bioethanol component.
m
WARNING
Always only use a safety petrol canister. Do not smoke when filling petrol. Remove any residual oil and petrol.
Switch the engine off before filling petrol and let the engine cool for several minutes.
Please also read the enclosed operating instructions of the petrol engine!
13. Commissioning
• Before commissioning observe the safety notes.
•
All safety and auxiliary installations must be fitted.
•
Check the rocker, which must return to the initial position independently. Check the saw blade for perfect fit and the
correct direction of rotation.
• Functional check before start of work.
• To operate the saw, press the on / off switch.
•
The saw is constructed solely for the cross cutting of firewood with max. 1 meter length.
• Regardless of the wood diameter, put only one piece with min. Ø 60 mm on the rocker.
• Use both hands to swing the rocker to the saw blade.
• Then place the rocker in the initial position.
•
The wood to be sawn must not be fixed by hand.
• After the complete standstill of the saw, pull the mains plug or the ignition plug.
• Only carry out conversion, adjustment, measurement and cleaning work with the engine switched off. Wait until the
rotating tool has come to a standstill and remove the mains plug / spark plug connector.
Starting the engine
Follow the procedures below for a cold
start:
1. Open the fuel valve (B) to the right in the
opening position.
2. Turn the choke lever (A) on the engine
fully to the left, to the “ON” position.
3. Move the throttle lever (C) on a semi-
open position.
4. Turn the ignition switch (E) to ON.
5. Pull slowly several times the reverse
starter handle (D) so that the fuel flows
into the carburettor. Then hold the
reverse starter handle (D) and pull the
cable out slightly until you feel resist-
ance. Then pull the cable in a quick
motion and let the cable rewind slowly again. Do not allow the cable to snap back. Tighten if necessary, the reverse
starter handle (D) repeatedly until the engine starts.
6. Let the engine warm up for a few seconds. Then gradually move the choke lever (A) to the right in the „OPEN“ position.
A
B
C
D
E
