14 english
Note:
Excessive tightness on the drive belt may cause increased noise and overload the motor. Excessive looseness on the
drive belt may cause the drive belt to fail prematurely and make a severe chattering noise.
• Using a phillips head screwdriver, reinstall the pulley cover and the two phillips head screws. Tighten securely.
Trouble shooting
Problem
Possible Cause
Help
Motor doesn’t start
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
a-d) Replace all damaged parts before you
use your machine again.
e)
Contact your local service centre.
Every attempt to carry out a repair, can
be dangerous if it is not done by skilled
personnel.
Machine gets slower
during work.
Too much pressure put on the workpiece.
Reduce the pressure on the workpiece.
Sanding belt comes
off the drive pulleys.
Belt does not run straight.
Reset the track.
The wood gets burnt
during sanding.
a) Sanding disc or belt covered with grease.
b) Excessive pressure on workpiece.
a) Replace disc or belt.
b) Reduce pressure on workpiece.
