www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
GB
| 27
6. Technical data
AC motor
220-240 V~ 50Hz
Power
1800 Watt
Operating mode
S6 40% 2200 W*
Idle speed
5200 min
-1
Carbide saw blade
ø 216 x ø 30 x 2,8 mm
Number of teeth
48/60
Swivel range
-45° / 0°/ +45°
Mitre cut
0°−45° left / right
Saw width at 90°
300 x 65 mm
Saw width at 45°
200 x 65 mm
Saw width at 2 x 45°
(double mitre cut)
200 x 38 mm
Protection class
II
Weight (incl. accessories)
13 kg
Laser class
2
Wavelength of laser
650 nm
Laser output
< 1 mW
* S6 40%, continuous operation periodic duty.
Identical duty cycles with a period at load fol
-
lowed by a period at no load. Running time 10
minutes; duty cycle is 40% of the running time.
The work piece must have a minimum height of
3 mm and a minimum width of 10 mm.
Make sure that the workpiece is always secured
with the clamping device.
Noise and vibration
Total vibration values determined in accordance with
EN 62841.
Sound pressure level L
pA
97,7 dB(A)
Uncertainty K
pA
3 dB
Sound power level L
WA
110,7 dB(A)
Uncertainty K
WA
3 dB
Wear hearing protection.
The effects of noise can cause a loss of hearing.
Total vibration values (vector sum - three directions)
determined in accordance with EN 62841.
Residual risks
The machine has been built according to the
state of the art and the recognised technical
safety requirements.
However, individual residual risks can arise dur-
ing operation.
•
Health hazard due to electrical power, with the use
of improper electrical connection cables.
•
Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re
-
main.
•
Residual risks can be minimised if the „safety in
-
structions“ and the „Proper use“ are observed
along with the whole of the operating instructions.
•
Do not load the machine unnecessarily: excessive
pressure when sawing will quickly damage the saw
blade, which results in reduced output of the ma
-
chine in the processing and in cut precision.
•
When cutting plastic material, please always use
clamps: the parts which should be cut must always
be fixed between the clamps.
•
Avoid accidental starting of the machine: the op
-
erating button may not be pressed when inserting
the plug in an outlet.
•
Use the tool that is recommended in this manual.
In doing so, your mitre saw provides optimal per
-
formance.
•
Hands may never enter the processing zone when
the machine is in operation. Release the handle
button and switch off the machine prior to any op
-
erations.
