page 16
Remove the beer mat or paper felt.
•
Open the thickness plate completely. Display shows
’OFF’
•
Position the carriage in the centre.
•
Lift up end piece holder
•
Mount the sharpening device in such a way to the
thickness plate that the cone of the sharpening device fits
into the slit on the bottom of the thickness plate (direction
of arrow)
•
Pull out the pin on top of the sharpening device in direction of
arrow and move the sharpening device over the edge of the
thickness plate.
•
Move the sharpening device with the pulled out pin to the front
in direction of the blade (direction of arrow), so that the pin is
engaged in the hole of the thickness plate.
•
The sharpening stones are now in the correct position, i.e.
the blade edge is positioned between the two sharpening
stones.
7.3. Sharpening the blade
•
Switch on the machine
•
When the thickness plate is opened the blade can be started by pushing the key
"stacking" (display shows
’on’)
.
•
Turn the yellow handwheel of the sharpening device in direction 1. By means of this the
sharpening stone sharpening the blade is pushed towards the blade.
•
Approximately 15 seconds are enough.
•
Switch off the machine by pushing the key "stacking" (display shows
’OFF’)
•
check if there has been built a visible burr at the edge of the blade
•
If not: Sharpen again
•
Switch on the machine again
•
For taking off the burr turn the yellow handwheel in direction 2. Now both sharpening
stones are touching the blade.
•
Approximately 2 seconds are enough to take off the burr.
•
When the sharpening procedure is terminated turn the yellow handwheel to 0.
7.4. Removing the sharpening device
•
Switch off the machine at the red main switch.
•
Pull the pin of the sharpening device upright in direction of arrow.
•
Tilt the sharpening device aside to the right.
•
Remove the sharpening device.
Now clean the machine entirely from wheel swarf, see chapter 4. Cleaning. First clean the machine with a dry cloth.
Then make a complete wet cleaning.
Attention! Risk of getting hurt!
Always work with concentration! Do not let distract yourself from your work!
Never check the sharpness of the blade with your fingers.
8. Maintenance
Clean the machine at least one time per day.
If necessary sharpen the blade.
In case the gap between blade edge and fixed protecting ring is more than 5 mm the blade has to be exchanged.
If necessary the sharpening stones have to be cleaned or exchanged.
For lubricating only use acid free oil.
0
1
2
15 sec.
< 2 sec.
