EasyBus - Signalling and Switching Bus System
Installation, Operating and Maintenance Instructions
EasyF-VMP connections | EasyF-RMM connections
Construction subject to change
No return possible
Version: 2017-11-13 | Page 5
EASYF-VMP CONNECTIONS
General:
The EasyF-VMP module is used for connecting and controlling
two MP-Bus-capable drives.
Cons. No.
Figure
Description
Terminals for connection to the EasyBus network
230 V AC
1
230V AC/50Hz
230V AC/50Hz
Zero conductor
Zero conductor
Programming and visualisation
2
7-segment display
and
programming key
Terminals for the motors
3 + 4
Ground (GND)
24V DC
Control signal 0 - 10V
Effective signal 0 -
10V
EASYF-RMM CONNECTIONS
General:
The EasyF-RMM module is used for connecting the smoke
detectors (RMSII-L) to the 230 V EasyBus network and is used
for duct monitoring.
Cons. No.
Figure
Description
Terminals for connection to the EasyBus network 230 V AC
1
230V AC/50Hz
230V AC/50Hz
Zero conductor
Zero conductor
Programming and visualisation
2
7-segment display and
programming key
9-pin Sub D connector for connecting the smoke detectors
3 + 4
GND
Pin 1
Fault NO
Pin 2
Centre contact fault
Pin 3
Fault NC
Pin 4
Test
Pin 5
Alarm NC
Pin 6
Centre contact alarm
Pin 7
Alarm NO
Pin 8
+24V DC
Pin 9
1
3
4
2
1
3
4
2