EasyBus - Signalling and Switching Bus System
Installation, Operating and Maintenance Instructions
Programming of EasyS-MV2 |
Construction subject to change
No return possible
Version: 2017-11-13 | Page 12
Changing the channel
To prevent interference or influences between two or several
EasyBus networks, it is recommended to use different
channels for each network.
In this submenu, the channel of the previously scanned EasyF
modules can be changed from the switch cabinet without the
need to go to the module on site.
Master is in function
Hold down the programming key >3s
flashes
Press the programming key until
appears
Hold down the programming key >3s
flashes three times
Hold down the programming key >3s
appears (flash frequency of the point 2x)
If required, select the desired number
by pressing the key
Hold down the programming key >3s
appears (flash frequency of the point 1x)
If
required,
select
the
desired
number
by pressing the key
Hold down the programming key >3s
7-segment display goes out briefly
"
flashes briefly
The display goes out briefly and then the master switches to
the corresponding Modbus status.
If several networks in a building have been
installed, the corresponding channels of
EasyS-MV2 must be adjusted
correspondingly. The channels 01 to 99 are
available.
It is further recommended that the other EasyBus networks
are switched off during channel change.
Activation of positive opening operation:
This function can be activated only for modules with assigned
addresses and after a successful scan.
Master is in function
Hold down the programming key >3s
flashes
Press the programming key until
appears
Hold down the programming key >3s
flashes three times and remains then visualised
EasyBus users go to the open position
Deactivation of positive opening operation:
Positive opening operation is active
Hold down the programming key >1s
appears
The deactivation functions only for
modules detected during a scan and having
an address.
The hardware contact is not deactivated.
Configuration of the Modbus parameters
At the EasyS-MV2, the Modbus interface can be
parameterised. The following values are set ex works:
Modbus address:
1
Baud rate
2 (19200 baud)
Parity 2
(pair)
Stop bit
2
Channel 01
Address entry
Speed entry
Parity entry
Time out entry
Display "b"
Display "A"
Display "b"
Display "P"
Display "t"