14
WALL ARM MOUNTING
The
ScentWave 1004
is equipped to allow mounting
to a wall surface using the mounting plate and
optional arm mounting kit and hardware.
ARM MOUNTING THE SCENTWAVE:
1. Remove the mounting ring from the base by
loosening the retainer ring on the universal
mount arm.
2. Hold the base in the desired location and
mark three (3) screw holes with pencil.
•
For drywall, drill a 1/4” (7.5mm) pilot
hole and use a screwdriver to drive the
provided white plastic anchors into the
wall.
(Fig.23)
•
Drive the screws into the holes, holding
the base in place.
3. Attach the Mounting Arm to the
ScentWave
.
•
Attach the mounting plate to the pivot
end of the wall mounting bracket
through the center hole using the
provided lock nut and screw. Tighten
using a screwdriver to secure the nut in
place.
(Fig.24)
•
Attach the mounting plate assembly to
the bottom of the
ScentWave
using the
provided plate screws and pilot holes.
4. Attach the assembly to the wall.
(Fig.25)
•
Attach the wall mounting arm to the
base using the retainer ring on the arm
and tighten at the desired angle. Adjust
the pivot end as necessary for a correct
angle and secure fit.
Pivot
Adjustment
Fig.23:
You can mount the retainer ring in any direction,
there is no up or down.
Fig.24:
You must attach the arm to the mounting plate
BEFORE attaching the mounting plate to the ScentWave.
Fig.25:
You can change the direction of the ScentWave
with the pivot adjustment screw.
NOTE: Ensure the ScentWave intended
to be mounted has four small holes
near the rubber feet for attaching
the mounting plate.
B
B
A
IDENTIFY YOUR DEVICE
