13
PLATE-LESS WALL MOUNTING
The
ScentWave 1005
is equipped to allow mounting
to a flat surface using the supplied hardware.
MOUNTING THE SCENTWAVE:
1. Using the template on the back of this
manual (page 16), mark the location on the
wall where the
ScentWave
will be mounted.
•
Choose either the small or large
openings to use for mounting.
•
For drywall, drill a 1/4” (7.5mm) pilot
hole and use a screwdriver to drive the
provided white plastic anchors into the
wall.
(Fig.21)
•
Drive the screws into the anchors
leaving 5/16” (7.9mm) between the
top of the screw and the wall.
2. Attach the
ScentWave
to the wall:
•
Line up the slots on the
ScentWave
system with the screws in the wall and
slide into place.
(Fig.22)
•
Remove the
ScentWave
and adjust the
wall screws as necessary for a tight fit.
5/16” (7.9mm)
Fig.21:
This example is using the large openings on the
bottom of the ScentWave for mounting to a wall.
Fig.22:
Adjust the mounting screws as needed to ensure
the ScentWave is securely in place.
NOTE: Ensure the ScentWave intended
to be mounted has the hole pattern on
the bottom of the system.
IDENTIFY YOUR DEVICE
