Fitting the Control Panel
1.
Choose a location where the user can operate the panel easily. (If fitting
a 602 choose a convenient location.)
2
Remove the lid screw and open the lid to the left. Note the slotted cen-
tral key hole located near the top of the back.
3.
Hold the panel in place and mark the position of the central key hole.
4.
Take the panel down and drill the centre fixing hole.
CAUTION: Do not drill holes with the panel in place. You will damage the
electronics.
5.
Fit the panel in place using the central key hole and mark the remaining
fixing holes.
6.
Take the panel down and drill the the remaining fixing holes.
7.
Secure the panel to the wall using suitable fixings (for example 30mm x
No. 10).
Note: Move Keypad Backlight On/Off Jumper (see Figure 6) onto one pin if
you wish to switch the keypad backlight OFF.
Wiring to the Mains
1.
Lead the mains cable behind the case and in through the mains cable
cut-out, just above the battery (see Figure 5).
2.
Connect the mains cable as shown in Figure 7 below.
Figure 7. Mains Connection
Warning: Do not apply mains power at this point.
Battery Connection
A 1.9(2.1)Ah maximum rechargeable battery will fit within the panel. Figure 5
shows the position of the battery within the case.
Connecting Detectors
Figure 8 shows the zone connector at the panel. Zones 1 and 2 share a com-
N
(L)P
T 200mA 250V
230V ~50Hz
500mA
To Control Panel
Transformer
11
Installation
496219 Issue 1
601 installation 23/10/1998 10:09 Page 11
