Scantool 320 GSHE, Руководство пользователя

Страница: 14 / 32

13
9-2. STARTING AND STOPPING MACHINE ( with handle switch)
1. The motor will be stopped when the Frame touch the Limit switch (K).
2.The coolant system will run and stop with blade operation.
3. Start the motor by turning the start button (K), Push the button (L) to start blade saw. Unhand button
(B) stop The motor.
9-3. AUTO / MANUAL MODE OPERATION
In the event of incorrect operation or dangerous,condition, press the E-STOP button (D) to
immediately shut off all functions of the saw. Twist the emergency stop button clockwise (cw) to reset.
Note: Resetting the E-STOP button will not start the machine.
1. AUTO MODE OPERATION
1-1 Close the handle on the hydraulic ball valve (I) by turning it counterclockwise (ccw).
1-2 Turn the flow control knob (AH) clockwise (cw) to shut off the hydraulic flow. This will prevent the
saw bow from dropping when the ball valve is opened.
1-3. Increase the bow weight. Rotate the wing nut (AI) counterclockwise (ccw) to decrease the tension
on the
spring.
1-4. Load piece part and clamp securely.
1-5. Turn the main switch (F) to "ON". Check to see that indicator light (A) is lit.
1-6. Set the blade speed with control knob (G).
1-7 Set switch (D) counterclockwise (ccw) to auto mode
1-8 Press the green start button (B). The saw motor and the coolant pump motor should both
start.
1-9 Open the ball valve (I) clockwise (cw).
1-10 Turn the flow control knob (AH) clockwise (cw) to slow down the descent or
counterclockwise (ccw) to speed it up.
2. MANUAL MODE OPERATION
2-1 Close the handle on the hydraulic ball valve (I) by turning it counterclockwise (ccw).
2-2 Turn the flow control knob (AH) clockwise (cw) to shut off the hydraulic flow. This will prevent the
saw bow from dropping when the ball valve is opened.
2-3 Reduce the bow weight. Rotate the wing nut (AI) clockwise (cw)to increase the tension on the spring
2-4 Load piece part and clamp securely.
2-5 Turn the main switch (F) to "ON". Check to see that the indicator light (A) is lit.
2-6 Set the blade speed with control knob (G).
2-7 Set switch (D) to manual mode for trigger operation.
2-8 While firmly holding the control handle of the saw bow, open ball valve (I) clockwise (cw).
2-9 Fully open the flow control knob (AH) counterclockwise (ccw).
2-10 Squeeze the start trigger to energize the blade motor and lower saw bow to begin cutting.
2-11 When saw bow reaches bottom limit, the micro switch (K) is actuated and shuts off the saw motor.
2-12 Return the saw bow to its start position and close ball valve (I).
2-13. Unclamp and reset the piece part to continue the next cutting cycle
K
L