GRINDING GUIDE FOR PRECISION ANGLES
1) Find the requested grinding angle on the grinding guide.
2) Place the grinding guide on the grinding wheel.
3) Adjust the tool rest in vertical position and push the tool rest up against the grinding guide. Tighten up the
thumb screws. Approximate distance to the grinding wheel: 1, 5 mm
4) Place the tool that needs sharpening on the tool rest and pull it from left towards right with a light pressure
on the grinding wheel.
NOTE!
To obtain correct grinding angle please hold the tool towards the tool rest during grinding.
GUIDE PLATE
This brilliantly simple precision alu tool rest is now standard on all wet grinders. The benefit of the tool rest is
to get a similar knife sharpening each time.
HOW TO USE WHEN GRINDING ON TOP OF THE WETSTONE.
For best results, the wet stone should turn towards the knife. Angle the tool rest so that the knife supports
are at the uppermost part of the stone. Draw the knife lightly and smoothly across the stone, holding it flat on
the tool rest. Only light pressure is required for a perfect finish. Turn the knife over, end for end, and grind the
opposite face, regularly checking the edge for even grinding. Finally, remove any microscopic burr with the
polish wheel (200-S) or a small slip stone.
FIG 1
ON-OFF-ON AFBRYDER
reversibel
2 YEAR WARRANTY
If within two year of purchase this machine supplied by
SCANTOOL A/S
becomes defective due to faulty
materials or workmanship, we guarantee to repair or replace the machine or the defective part or parts free
of charge provided that:
1) The product is returned complete to one of our service branches or official service agents.
2) The product has not been misused or carelessly handled and in particular has not been used in a manner
contraty to the operating instructions.
3) Repairs have not been attempted by persons other than our own service staff or the staff of our official
service agents.
4) Documentary proof of purchase date is produced when the goods are handled in or sent in for repair.
NOTE!
Before you start grinding make sure
the stone rotates in the right direction (pic. 2)
Rotatio
