Scanna Msc SCANMAX 25 C, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 30

Fit the new Controller in reverse order
S1. Fit the Controller module.
S2. Refit the connectors to the Controller module.
S3. Refit the rear connection panel and test the unit. Check the panel interlock for correct
operation
Door Adjustment: This must be carried out by service representative
To re-seat the door in case of mechanical trauma or accidental loosening of screws, use the following
procedure:
S1 . Loosen screws on right side of door and back out the set screws until flush with the
hinge.
S2 . Lift the door and secure the screws. This should eliminate radiation leakage at the door. Be sure
that the plunger interlock on the door is not damaged.
S3 . Re-tighten screws to fix position. Tighten set screws to ensure that setting does not change. Set
screws can also be used to provide a very slight adjustment from left to right if needed.
S4 . Test for radiation leakage and correct as needed. You must reject the unit at this point if levels
of 1
µ
Sv/hr are exceeded.
Final re-seating of the door should be performed in conjunction with radiation testing to ensure that proper
fit has been achieved. Door fit was correct upon shipping of the unit from the factory if proper installation
instructions have been followed.
The attached Maintenance Report Sheet should be completed by the engineer carrying out the maintenance.
Camera Adjustment and Cleaning
Disconnect the unit from the mains supply.
If carrying out adjustments in the bottom of the unit to the camera and its lens whilst the unit is energised
be sure to keep all parts of the body and metallic tools clear of the Isolating transformer and any wiring.
The camera is accessed by removing the front control box.
Three screws on the base of the control box are removed and the box carefully lifted taking care not to put
tension on the connections to the control panel.