#SC 40RT 06 – 101027
Page 26 of 44
9. Removal of Location Sleeve/Inlet Housing
To remove the inlet housing or the location sleeve, the following procedure
should be followed:
1. Lift up the tank cleaning machine from
the tank
2. Protect the upper magnet, on the drive
unit, from dirt and damages
3. Undo the cofferdam plug (A)
4. Undo the stopscrew (B) in the top nut
5. Undo the top nut (C) by using tool
30080
6. Use the other end of tool 30080 and
undo the location sleeve (D)
7. Change the seals and replace the
location sleeve
8.
NOTE!
Prior to remounting the inlet
housing, the O-rings inside the location
sleeve have to be protected against
damage by using some tape on the
thread of the top shaft.
9. Look through the cofferdam hole and
turn on the top nut until you have a full
view of one of the grooves in the top
shaft through the hole in the top nut.
Use the groove to lock the stopscrew
(B) into the top shaft. Use Loctite on the
stopscrew (B).
10. When changing pos. 125, remove inlet house completely.
NOTE!
Watch hands and eyes when
removing the cofferdam plug in
case of leakage, use protection gog-
gles and gloves.
B
C
D
A
Bearings
O-rings
O-ring
Protect!
Designer
Date
Date
Drawer
Surface treatment
Weight
Note
Dimension
Material
General Tolerances
Tolerance ISO 2768-m Gen. surface
N9
This document is our property and shall not without our permission in writing be altered, copied, used for manu- facturing or communicated to any person or company.
Drawing no. / Ritningsnr.
Format
SC40RT
A4
Scale
SC40RT
1:5
SC40RT
Denna handling är vår egendom och får ej utan vårt skriftliga medgivande ändras, kopieras, användas för tillverkning eller delges annan person eller firma.
SS-ISO 2768-m for machined parts
(30)-120=
0.3
0.5-3=
0.1 (120)-315=
0.5
(3)-30=
0.2 315)-1000=
0.8
P03.1
Törnedalsgatan 1, 275 21 Sjöbo
SWEDEN
ML
Revision
05-04-19
E
No.
Revision note
Date
Sign.
Qty.
Ins.
gram
