Scandomestic SFS 272 W, Руководство пользователя

Страница: 38 / 77

Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician
or competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
Problem Possible cause Solution
Appliance dose not
work Mains plug is not plugged in or is loose,
or product is turn off Insert mains plug and turn on the appli-
ance
Fuse has blown or is defective Check fuse, replace if necessary.
Socket is defective Mains malfunctions are to be corrected by
an electrician.
Appliance freezes
too much Temperature is set too cold or the
appliance runs at -22' C setting. Turn the temperature regulator to a
warmer setting temporarily.
The food is not
frozen enough. Temperature is not properly adjusted. Please look in the initial Temperature
Setting section.
Door was open for an extended period. Open the door only as long as necessary.
A large quantity of warm food was placed
in the appliance within the last 24 hours. Turn the temperature regulation to a
colder setting temporarily.
The appliance is near a heat source. Please look in the installation location
section.
Heavy build-up of
frost on the door
seal.
Door seal is not air-tight.
Carefully warm the leaking sections of the
door seal with a hair dryer (on a cool
setting). At the same time shape the
warmed door seal by hand such that it sits
correctly.
Unusual noises Appliance is not level. Re-adjust the feet.
The appliance is touching the wall or
other objects. Move the appliance slightly.
A component, e.g. a pipe, on the rear of
the appliance is touching another part of
the appliance or the wall. If necessary, carefully bend the compo-
nent out of the way.