Position The Appliance
Position the appliance in the desired location. The back should rest against the wall behind it,
and the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water
supply and drain hoses that can be positioned either to the right or the left sides to facilitate
proper installation.
Levelling the appliance
Once the appliance is positioned for levelling, the height of
the dishwasher may be altered via adjustment of the
screwing level of the feet.
In any case,the appliance should not be inclined more than
2°C.
NOTE:
Only apply to the free standing dishwasher.
Free Standing Installation
Fitting between existing carbinets
The height of the dishwasher, 845 mm, has been designed in
order to allow the machine to be fitted between existing
cabinets of the same height in modern fitted kitchens. The
feet can be adjusted so that correct height is reached.
The laminated top of the machine does not require any
particular care since it is heatproof, scratchproof and
stainproof.
Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is only one single work
top under which cabinets and electrical appliances are fitted.
In this case remove the work top of the dishwasher by
unscrewing the screws under the rear edge of the top (a).
Attention
After removing the work top, the screws must be screwed
again under the rear edge of the top (b).
The height will then be reduced to 815 mm, as scheduled by the International Regulations
(ISO) and the dishwasher will fit perfectly under the kitchen working top