Scandomestic BIK 343W, Руководство пользователя

Страница: 29 / 64

CHANGE THE OPENING DIRECTION OF
YOUR PRODUCT 3/3
5. Flip the lower hinge
180"(so the pin is
pointing downwards)
and put the pin of the
hinge into the top of
the door and fix it in
to place. Ensure the
door is aligned hori-
zontally and vertically
so that the seals are
closed on all sides be-
fore finally tightening
the top hinge pin.
6. Remove the 2 door
guide holders from
side of the doors and
fix them on to the op-
posite side.
VENTILATION 1/2
The main consideration when installing any refrigeration unit
into a fitted kitchen is ventilation. The heat removed from the
Cooling compartment needs to be dissipated into the atmos-
phere. Incorrect ventilation can lead to premature compres-
sor failure, excessive power consumption, total system failure
and may invalidate the warranty provided with the appliance.
For products intended to be installed into a tall housing unit,
The following requirements need to be met: Make a 200 cm²
opening for the ventilation
VENTILATION 2/2
•
An air passageway should be provided in the top of
the cabinet run to allow free air in and out.
•
There should be space at the rear of the cabinet to
allow cool air to be drawn over the condenser. Rec-
ommended: 500 x 35mm.
•
A cutout should be made in the plinth below the
fridge/- freezer and this finished neatly using the air
vent grille. Alternatively, a thin section of the plinth
can be removed to allow air into the unit
(recommended 600mm x 10mm)
INSTALLATION 1/9
1. Install the door hinge well before you put the prod-
uct into the cabinet.