scandia AVEDUR SCGAS10, Руководство пользователя

Страница: 14 / 31

Inlet
pressure
Outlet
pressure
Max adj.
nut
Min adj. screw
The heater is configured for natural gas by default. Use conversion kit included in packaging to do propane gas type
conversion. Please follow the steps below to convert the heater to propane gas:
STEP 1
STEP 5
STEP 9
STEP 2
STEP 6
STEP 10
STEP 3
STEP 7
STEP 11
STEP 4
STEP 8
Replace the main burner injector using the
injector provided in the conversion kit.
Remove and replace the pilot injector using
the injector provided in the conversion kit.
Remove the selector jumper as shown
in the image below. This will activate the
propane configuration of the control
board.
Using a spanner, remove the nut to access
the pilot injector.
Locate the Millennium control board and
remove three screws as shown in the image
below. Carefully lift the cover to access the
selector jumper inside.
Please refer to the compliance plate/
product specification table to ensure the
correct injector size.
Please refer to the compliance plate/
product specification table to ensure the
correct injector size.
Change the outlet pressure of the gas
valve to suit propane gas type. Inlet and
outlet test points may be used to check the
pressure while doing the adjustments.
Remove two screws and carefully remove
the pilot burner assembly.
Change the primary aeration opening to
suit the propane gas type. Please refer to
the compliance plate/product specification
table to ensure the correct opening size.
A SIT pressure adjustment tool may be used to adjust the pressure. Alternatively a phillip
head screw driver and a 10mm spanner can be used. When adjusting the maximum
pressure, hold the screw driver in place and turn the spanner. When adjusting the
minimum pressure hold the spanner in place and turn the screwdriver.
Main Burner
Injector
Selector
Jumper
Pilot
Injector
13.
INSTALLATION GUIDE
GAS TYPE CONVERSION