3
PART NUMBER
CCS TYPE 2
CHAdeMO
206.D91-E10
●
206.D91-E11
●
206.D91-E12
●
●
PART NUMBER
Description
208.AP62
CCS type 2 IP54 IK10 connector holder
208.AP63
CHAdeMO IP54 IK10 connector holder
208.AP64
Filter Cloths KIT
DISCLAIMER AND PURPOSE OF THIS MANUAL
BE-D wallbox should be installed, operated, serviced, and maintained only by qualified personnel. No
responsibility is assumed by SCAME PARRE S.p.A. for any consequences caused by improper use of this material.
The technical documentation is an integral part of this product. Always keep it at hand until the unit reaches its
end of life, as it provides important information. It should also be shared with all the people concerned if you sell,
assign or lend the product to others. This guide must be read in integrality along with others related documents.
It is prohibited to use extension cords to connect the vehicle. Adaptors or conversion adapters are not allowed to
be used either.
ACCESS CONTROL AND IDENTIFICATION MODES
Starting a charging session on BE-D wallbox can be done by selecting different access profiles, depending on the
installation site and use cases of interest.
Access profile configuration must be done via Scame’s local management system.
To access the management system one shall connect to the station network and enter their credentials. No
software installation is required.
IP address(DEFAULT):
Username: administrator
Password: Admin123
Free access mode
In access controlled locations, such as gated and fenced areas, the unit is typically setup in free mode, i.e.
anybody able to physically access the charger is authorized to use it by default. In other words, no explicit user
identification is needed in order to e.g. start or stop charging sessions. The built-in RFID card reader is therefore
disabled.
The selected operating mode of the charging station is displayed on the management system interface under the
