DOMA019EN v8_10-2015– Shado
®
User Manual
Page 11 / 24
Charge of the battery
•
Plug the AC plug into the main plug.
•
The green light turns on.
•
The orange light turns on when the battery is plugged correctly.
•
If the battery is completely discharged, charge it for at least 8 hours before using it again.
After a charge cycle, do not forget to cut out the main/24Vcc transformer from
the main circuit then from the Shado
®
connection current collector. The
transformer is not guaranteed if the feeding cord is cut (even partially).
It is not possible to over-charge the batteries. However, in order to guarantee
good performance of the equipment, it is recommended to apply a few minutes
break after having charged the battery and before use. It is also important to
completely charge the battery.
We advise you to use a wall charger and a replacement battery in order to insure
permanent use of the Shado
®
.
The wall charger for the electric Shado
®
The battery is fixed on these supports (unit /
wall charger). To withdraw, grab the handle A
and pull as indicated by the C arrow.
The stop motion device of the handle should
release itself from the support joggles.
To replace the battery, go through these steps
in reverse order while taking care that the
battery is properly positioned.
The green light is on when the wall charger is
plugged in.
The orange light is on when the battery is
being charged.
If the battery is completely discharged, charge
it for at least 8 hours before using it again
.
C
A
