10
Section 4
R
CAUTION
Do not attempt to operate this machine unless
you have read this manual. Learn the location and
purpose of all controls and instruments before
you operate.
4.1 CONTROLS AND INSTRUMENT
IDENTIFICATION
Before operating the truck loader, familiarize yourself with
all truck loader and engine controls. Knowing the location,
function and operation of these controls is important for
safe and efficient operation.
OPERATING INSTRUCTIONS
1. Ignition Switch (Figure 4-1).
The ignition switch
is used to start the engine and has three positions;
OFF, ON, and START.
2. Engine Throttle Control (Figure 4-1).
Used to
control the engine speed. Pushing the lever inboard
increases engine speed. Pulling the lever outboard
decreases engine speed. Full outboard position
is the IDLE position. Full inboard is the operating
position.
3. Engine Choke Control (Figure 4-1).
Used to start
a cold engine.
4. Tongue Jack (Figure 4-1).
Used to raise and lower
the ball hitch receiver or optional pintle hitch onto or
off of the tow vehicle.
5. Safety Chains (Figure 4-1).
Used to connect to the
tow vehicles cradle draw bar in criss-cross fashion in
case of an accidental disconnect.
REAR SUPPORT
LEG
ENGINE THROTTLE
CONTROL
ENGINE CHOKE
CONTROL
TONGUE
JACK
INTAKE HOSE
BOOM ASSEMBLY
FUEL TANK
GAUGE
IGNITION
SWITCH
FUEL SHUTOFF
VALVE
SAFETY CHAINS
OPTIONAL
Figure 4-1. Controls and Instruments
Содержание TLB25-35BV Series
Страница 13: ...9 Section 3 R...
Страница 25: ...21 R Section 6 NOTES...
Страница 28: ...24 Section 6 R 1 2 2 3 4 10 11 6 7 8 9 12 7 6 3 5 IMPELLER HOUSING ASSEMBLY...