System Setup
2.2.2 LPCM OUTPUT
When
DIGITAL OUTPUT
is set to
SPDIF/PCM
, this item is available.
Select a sample rating for the analog audio output. There are two options, 48KHz and 96KHz.
NOTE:
Some amplifiers don't support 96KHz sampling which will affect the coaxial output.
2.3 KARAOKE SETUP
2.3.1 MIC SETUP
2.3.1.1 MIC
Set this item to
ON
/
OFF
to switch on/off the connected microphone.
2.3.1.2 MIC VOL
Enter this item, then use direction key [
]/[
] to adjust the microphone volume. Then press [ENTER] to confirm
you adjustment.
2.3.1.3 ECHO LEVEL
Enter this item, then use direction key [
]/[
] to adjust the microphone echo level. Then press [ENTER] to confirm
you adjustment.
2.4 CHANNEL DELAY
This item is used to set the delay time for the center speaker, rear speakers and the subwoofer. The delay is to
compensate for the audio propagation time difference caused by the distance difference of the speakers to the
listener.
Use the direction key [
]/[
] to select the center speaker, subwoofer, left surround speaker or right surround
speaker.
Then use the direction key [ ]/[
] to set the distance difference.
NOTE:
The unit does not support delays when the distance between the center or surround speakers and the listener are
longer than that between the front speakers and the listener.
In case the channel delay settings cannot match your speaker configuration, please set all distance difference to
0cm. If possible, use your receiver/amplifier to set the channel delay.
-11-
