SawStop TSA-FOT, Руководство пользователя

Страница: 46 / 72

41
TSA-FOT OWNER’S MANUAL
WITHOUT WING
7
Position one of the rear rail clamps next to one of the table tubes (A) attached
to the insert table (D), so the opening in the rear rail clamp (the side with the
set screw) extends away from the table roller (F), and the clamp mounting
bracket extends under the table tube. Align the hole in the top of the clamp
mounting bracket with the clamp mounting holes in the table tube, so the
clamp mounting bracket extends under the table tube, but the rear rail clamp
does not.
Insert an M6 x 20 socket head cap screw down through the large and small
clamp mounting holes in the table tube, then through three M6 x 16 washers,
the hole in the top of the clamp mounting bracket, four M6 x 16 washers, and
an M6 lock nut. Use a 5mm hex L-wrench and a 10mm wrench to tighten the
lock nut.
Repeat this process for the table tube attached to the other side of the insert
table. The rear rail clamps should extend away from each other (see Fig. 41
for reference).
No procedure is needed for the other rear rail clamp at this time, as you will need to
check (and potentially adjust) the height of the table tubes relative to the table saw.
i
Fig. 41
A
A
F
D