SawStop TSA-FOT, Руководство пользователя

Страница: 22 / 72

17
TSA-FOT OWNER’S MANUAL
WITH WING
Recheck the alignment and move more washes as necessary. Then repeat
this adjustment for the clamp on the other side of the insert table. Recheck
both table tubes to make sure they are still correct.
Use a 5mm hex L-wrench to loosen the set screws and remove the rear rail
clamps from the rear rail.
Set the table tubes with the insert table and large roller aside.
Position one of the two remaining rear rail clamps between one of the sets
of table tubes (A) attached to a small table roller (E), so the rear rail clamp is
between the table tubes, the clamp mounting bracket extends under one of
the table tubes, and the open end of the clamp extends away from the small
table roller (see Fig. 13 for reference).
Align the hole in the top of the clamp mounting bracket with the clamp
mounting holes in the end of the table tube. Insert an M6 x 20 socket head
cap screw down through the clamp mounting holes in the table tube, then
through the same number of M6 x 16 washers you needed between the
10
Fig. 12