SawStop TSA-FOT, Руководство пользователя

Страница: 12 / 72

7
TSA-FOT OWNER’S MANUAL
WITH WING
INSTALLING WITH
THE EXTENSION WING
PAGES:
7-32
The first step in assembling the Folding Outfeed Table is to assemble the three
table rollers (E and F) and attach two table tubes (A) to each table roller. There are
five holes in the top and bottom surface of each table tube: one solitary hole and
two sets of two holes paired together, and the end with the solitary holes goes near
the table saw. The sets of paired holes are used to mount the table tubes (A) to the
table support tubes (B), and the solitary holes are used to attach the rear rail clamps
(K) (see Fig. 1 for reference).
The table support tube mounting holes and clamp mounting holes on the top
surfaces of each table tube are larger than the corresponding holes on the bottom
surfaces of the table tubes. This allows socket head cap screws to be inserted to
secure the table tubes to the table support tubes. Not all of the paired holes are
used to mount the table tubes to the table support tubes; different holes are used
for different configurations.
There are five solitary holes in both sides of each table tube: the ones furthest from
the clamp mounting holes are used to attach a table roller to the table tube, and are
not used in every table tube.
The rear three holes on each side of the table tubes are used for mounting the insert
table (see Fig. 1 below for reference).
Table support tube
mounting holes
Table support tube
mounting holes
Rear rail clamp
mounting hole
Insert table mounting holes
Table roller
mounting hole
A
Fig. 1