
21
Operating instructions for the user - Figure
5
1
Operating modes
You can start the sauna control directly via the
Quick-Start feature (refer to chapter 5) or after the
set desired time has elapsed - time until the stove
turns on (refer to chapter 6).
2
Displays
Self-testing of the control (display
flashes).
Heater is running.
Heater is not running.
3
Error messages
3.1
Displayed error messages
4
:
An error message signals an electrical defect of the
system.
The control is no longer ready-to-operate:
1. Write down the error message.
2. Switch off the main fuses of the control in
the fuse box.
3. Contact customer service.
4. Mark the control as being defective.
Using the following displayed error messages
4
you can inform customer service of possible errors/
defects.
The error messages mean:
E-F1:
short in line / break in
line/ stove sensor defective
E- 12:
break in line or defective
overtemperature protector.
E-P I:
damage of the potentiometer
6
for temperature setting
3.2
Red signal lamp
5
flashes:
Automatically, the control will turn off the heater if
the overtemperature protector has responded.
The control is no longer ready-to-operate:
1. Shut off the main fuses of the control in the
fuse box.
2. Contact customer service.
3. Mark the control as being defective.