Sawmaster M1030, Руководство пользователя, Страница: 17 / 33

16
Troubleshooting
Problem Possible Cause Solution
Machine does not run when switched
on
Power cord not properly fi xed/
plugged in
Check that the machine is properly
connected to the power supply
Power cord defective Have the power cord checked, re-
place if necessary
Main power switch defective Have the main power switch checked
and replace if necessary by a quali-
fied electrician
Loose electrical connection inside
the electric system
Have the whole electric system of
the machine checked by a quali fi ed
electrician
Motor defective Have the motor checked and re-
placed if necessary by a quali fi ed
technician
Motor stops (power cut out) Too much pressure exerted while
cutting
Exert less pressure when cutting
Incorrect specification for saw blade Use a saw blade which corresponds
to the material being cut
Saw has a defective electric system Have the electric system of the saw
checked by a quali fi ed technician
Poor machine performance, little
power
Power cord/extension cable too long
or cable still wound up inside cable
drum
Use a power cord/extension cable of
the rated length, use a cable drum
with cable fully extended
Power network is insuf fi cient Observe the electrical ratings of the
machine and connect it only to a
power network which complies with
these ratings
Drive motor no longer runs at rated
speed (RPM)
If error light is flashing on post have
the whole electric system of
machine checked by a qualified
electrician
Ground fault detected within the saw
If error light is flashing on post have
the whole electric system of
machine checked by a qualified
electrician
Ground fault detected within the saw
Have the power network checked by
a qualified electrician