Sawmaster M1030, Руководство пользователя, Страница: 11 / 33

10
CUTTING DEPTH
WARNING:
The recommended cutting depth is 1/4-in below the cutting
table surface. To adjust the depth raise/lower the blade by
loosening the depth adjustment knob and use the plunge
handle to adjust the blade depth as necessary. (see
figure 8)
The blade may grab the material being cut, causing
damage and possibly injury.
Blade Diameter Cutting Depth
10-in 2.4-in
ADJUSTABLE ANGLE GUIDE
WARNING:
Always lock the Adjustable Angle Guide to the table
prior to transporting the saw.
WARNING:
Always lock the cutting table prior to transporting the
saw.
The Adjustable Angle Guide is a two-piece assembly consist-
ing of a base and an attachment that rotates. This guide will
support cutting angles between 0° and 180°. The attach-
ment has a casted angle indicator that show markings every
5° with numerical markings every 45°. (see figure 9)
fi gure 9
USING THE CUTTING TABLE
The ruler guide has inches marked along the top to allow
convenient measurements and to promote precision cuts.
(see figure 10) With the side extension table installed, the
table spans 28-in x 23.15-in. If equipped with the rear
extension the table will span 28-in x 32.2-in, which allows it
to provide greater support for handling larger materials.
Cutting table is covered by a rubber mat that provides a firm
durable work surface. A guide should be used together with
the cutting table to ensure precision while making cuts.
fi gure 10
USING THE GUIDE FOR RIP AND DIAGONAL
CUTS
The motor should be turned off when adjusting the material
being cut.
1
2.
3.
4.
5.
For rip cuts . Set the tile such that the desired cut
lines up with the blade.
Next adjust the adjustable angle guide such that the
rotating attachment is set at either the 0° or 180°
position. 0° if the guide is to be placed to the left of the
material, or 180° if the guide is to be placed to the right
of the tile. (see figure 11)
Position the guide so its attachment’s flat side rests flush
against the material to be cut. (see figure 8)
Tighten the threaded knob. Now you are ready to cut.
For diagonal/angled cuts . Adjust the adjustable angle
guide such that the rotating attachment is set at an angle
that matches the desired cut line to be made on the tile.
(continue on page 11)
Attachment flat side
Attachment
Ruler guide