Sawmaster M1030, Руководство пользователя, Страница: 16 / 33

15
WARNING:
For your safety, before performing any maintenance
on the saw turn off the power switch and unplug the
power cord.
Before & After A Prolonged Time
Clean saw as described
in the
Saw Maitenance
section and lubricate all
movable parts. DO NOT
GREASE the GUIDE
RAILS.
Check that the legs are
safely fixed.
Check that all screw and
nut points are tightened
correctly.
Check that the roller table
is rolling on the rails and
that it moves securely
back and forth.
With the saw blade
removed, switch on the
motor for an instant and
switch it off again. If the
motor does not run, have
the machine inspected by
a qualified electrician.
•
•
•
•
Before not using the
machine for a prolonged
period of time
After not using the
machine for a prolonged
period of time
Temperature Changes
To prevent the water in
the pump and cooling
system from freezing,
remove the water after
using the machine or
when there will be a long
break. Make sure that
the cooling system is
entirely drained so that
there is no water left
inside the pump, the
bearing house and the
water hose!
•
Ambient Temperature
Below 37 F (Winter)
When the machine has not been used for a long period
of time, hard packed dirt may build up inside the pump
and block the pump fan from rotating. If the machine is
activated with the fan blocked, the electric motor inside
the pump will overheat within a few minutes! Please
follow the steps listed below to clean the pump before
operating the saw.
Water Pump Maintenance
1.
2.
3.
4.
5.
6.
7.
Remove the water pump from the water tray/container.
Clean the water pump exterior.
Clean the interior where the fan is by removing the fan
cover. If gasket is installed, be careful not to damage it.
The fan can be removed by using pliers to pull it off.
Careful not to damage the fan or the motor shaft. With
it removed, the entire volute can be cleaned easily.
Spin the pump shaft by hand. It should rotate almost
effortlessly. Then press the cleaned fan back onto the
blade. Note to align the shaft geometry with that of the
blade bore before pressing it back on. Do not press the
fan too far down the shaft or it may not rotate. Spin the
fan blade by hand to confirm it can spin effortlessly.
Reassemble the fan cover.
Turn the saw on briefly to check whether the pump
works properly.
WARNING:
Disconnecting the water pump should be done by a
certified electrician.
M1036 • Owner’s Manual