8
10. ATTACHING THE FAN
BLADES
Insert the blade through the slot in
housing. Align holes in blade and motor
and secure with 3 screws and blade
support plate. Repeat process with the
other blades. (Fig. 16)
Figure 16
Figure 17
11. INSTALLATING THE
MOUNTING PLATE
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box.
1. Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
2. Connect the 2-P connectors from the
light kit and fan.
3. Place the key holes on the light kit over
the 2 screws previously loosened from the
mounting ring, turn light kit until it locks in
place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one
previously removed. (Fig. 17)
Blade
Blades support
plates
Screws
Slot
Mounting ring
Mounting plate
Screws
2-P connectors