5
6. INSTALLATION OF
SAFETY SUPPORT
An additional safety support is provided to
prevent the fan from falling. Secure the
safety cable to the ceiling joist with screw
and washer, as illustrated in Figure 9.
7. MAKE THE ELECTRIC
CONNECTIONS
WARNING:
To avoid possible electrical
shock, be sure electricity is turned off at the
main fuse box before wiring.
NOTE:
This remote control unit is
equipped with 16 code combinations to
prevent possible interference from or to
other remote units. The frequency
switches on your receiver and transmitter
have been preset at the factory. Please
recheck to make sure the switches on
transmitter and receiver are set to the
same position, any combination of settings
will operate the fan as long as the
transmitter and receiver are set to the
same position. (Figure 10)
Step 1.
(Fig. 11) Insert the receiver into the
mounting bracket with the flat side of the
receiver facing the ceiling.
Step 2.
(Fig. 12 and 13) Motor to Receiver
Electrical Connections: Connect the Black
wire from the fan to Black wire marked "TO
MOTOR L". Connect the White wire from
the fan to the White wire marked "TO
MOTOR N" from the receiver. Connect the
Blue wire from the fan to the Blue wire
marked "For bottom Light" from the
receiver. Connect the Orange wire from fan
to the Orange wire from receiver marked
"For Upper Light". Secure wire connections
with the plastic wire nuts provided.
Hanger bracket
Safety cable
Figure 9
Figure 10
Figure 11
Code switch
ON
ON
Receiver
Hanger
bracket