Wireless Configurable Keypad for DMX Control - QRG
4 of 5
45 Perseverance Way, Hyannis MA 02601.
Copyright© 2021 Savant Systems, Inc. | 009-2075-00 | 211015
| 508.683.2500
1. At the main breaker panel, switch off the breaker that supplies power to the keypad.
NOTE:
Skip steps 2-5 when this is a new installation.
2. Remove the keypad’s wall plate from the wall plate adapter.
3. Unscrew the two #6-32 x
1/4
inch flat head screws and remove the wall plate adapter.
4. Unscrew the two #6-32 x
3/4
inch pan head screws and pull out the existing keypad.
5. Unplug the 4-pin connector from the rear of the keypad.
6. Using the
from the previous few pages, connect the wires from the 4-pin connector to the in-wall wires using an
approved wire nut or a similar alternative. If replacing an existing keypad, ensure the connections made to the 4-pin connector are
correct and secure.
7. Plug the pigtail wire into the rear of the keypad. The connector is keyed and can only be plugged one way.
Removal and Installation
8. Insert the keypad into the electrical switch box and secure
using the #6-32 x
3/4
inch flat head screws provided. DO NOT
use a powered screwdriver. A powered screwdriver can over-
tighten the screws.
9. Install the wall plate adapter using the #6-32 x 1/4 inch screws
supplied with the adapter.
10. Switch on the breaker to apply power to the keypad. The
keypad will go through an initial boot sequence and when the
sequence completes, the six LEDs on the dimming array will
begin blinking white in an alternating pattern. This pattern
indicates the keypad is not currently communicating on the
local Wi-Fi network. See the
page for more LED sequence information.
11. The next step is to provision the keypad to the local Wi-
Fi network. Information on provisioning is available in the
Wireless Keypad Provisioning Guide
. This guide and others can
be located from within the
Lighting Documentation Portal
on
the
Wall Plate and Adapter
Sold Separately
Wall Plate
Adapter
Wall Plate
Mounting
Screws
Electrical
Switch Box
12. With the keypad is provisioned, snap the wall plate into the wall plate adapter. The keypad is now ready to be added to a Savant
system. Blueprint programming information is available in the
DMX Low Voltage Deployment Guide
. This guide is also available from
within the
Lighting Documentation Portal
on the
.
Whether installing a new keypad or replacing an existing one, refer to the instructions below.
IMPORTANT NOTES:
–
When working with electricity, even low voltage electricity, follow all standard electrical and safety precautions to avoid leaving
exposed or bare wires that can short and cause damage to the equipment or yourself.
–
Savant recommends a licensed electrician be used to make the electrical connections. When working with AC voltage, a licensed
electrician is required.
