Wireless Configurable Keypad for DMX Control - QRG
3 of 5
45 Perseverance Way, Hyannis MA 02601.
Copyright© 2021 Savant Systems, Inc. | 009-2075-00 | 211015
| 508.683.2500
DMX-DRIVER3
No Connection
No Connection
No Connection
No Connection
No Connection
D+ (data)
D- (data)
Ground
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 2
Pin 1
WPX/WIX-xxLV06
Back Panel
-
+
D+
D-
120/240V AC
OUTPUT
INPUT
Blue = Neutral
Green w/Yellow Stripe = Gnd
black = V-
+24V DC Input
red = V+
Brown = Gnd
HLG-240H-24
POWER SUPPLY
GND
DMX Input
DMX in/out
1
1
8
8
DMX in/out
D-
D+
D-
D+
W2/WW
W1/CW
B/WW
G/CW
R/WW
V+
V+
V-
V-
+
DMX-DRIVER3
Wiring for the
WRGB LED
Strip shown
DC +24V
G
R
B
W
24V DC Gnd
24V DC Input
D+ (data)
D- (data)
Black
Red
Blue
Yellow
Station Pigtail
Length - 5
½
inches
Gauge - #22 AWG stranded.
SHA-W1000
CAT-5e/6
Pinout for DMX Ports
CAT-5e/6
24V DC
DMX IN
DMX OUT
P3
ON
OFF
DMX IN
DMX OUT
P3
ON
OFF
Set the Dipswitch on the
last fixture in the chain to ON.
(End of Line Terminator)
Daisy-chain connections
between lighting fixtures.
DMX Out
→
DMX In
DMX
LIGHT
FIXTURE 1
DMX
LIGHT
FIXTURE 2
RJ-45 Connector
(Gold pins facing up)
Pin 1 Pin 8
Additional Information
–
Savant recommends using the SHA-W1000 cable when making connections between the DMX-DRIVER3 and DMX keypad. Shown
in the diagram above is the SHA-W1000 cable with the recommended wire colors and connections.
–
Savant recommends the HLG-240H-24 power supply shown in the diagram. This transformer can supply the 24V DC needed to
power the DMX keypad and LED driver. However, other power supplies such as the SHA-POWSINGLE transformer or the +/- ports
on the SKL-3040/1010 keypad power and control module can be used.
–
section in the table above when making connections between the DMX Keypad and DMX Driver.
–
Up to 32 DMX devices are supported on each DMX keypad. This includes the combination of drivers, lighting fixtures, and LED
strips. Do not exceed 32 RDM devices as listed in the RDM tab of the OLA server.
–
Maximum distance of the DMX cable is 1600 feet. This is the total distance daisy-chained through all fixtures.
–
Set the dipswitch on the last fixture in the chain to ON. The last fixture is regarded as an end of line terminator.
–
Do not run DMX signaling in the same conduit as the high voltage AC lines.
–
Fixtures/loads will not illuminate when there is no DMX signal present
–
See the DMX Keypad Deployment Guide on the
for additional wiring diagrams.
The image below shows the DMX-DRIVER3 providing control to both an LED strip and a USAI DMX lighting fixture. Use the diagram
below for reference when connecting the various type loads.
