* Either of the capacity mode or elapse time will be disabled when you choose value as OFF.
** The setting procedure will be terminated, and go back to the original status if there is no input
for 10 seconds.
5.6 Operating
The DigiFlow 8000T will be automatically turn on when there is water flowing through the sensor.
It will automatically turn off in 10 seconds when there is no water flowing.
5.7 Mode Selection :
Press DISPLAY button is to display the status of the three modes of the DigiFlow 8000T.
1. Filter remaining capacity mode, 2. Filter remaining elapse time and 3. Flow rate.
5.8 Alert
5.8.1 Near End o Life Alert
When filter remaining capacity is less than 30 gallons (100 liters) or filter remaining elapse time is
less than 7 days, the buzzer will beep once and the digit will blink to notice user that the filter
cartridge is near its end of life.
5.8.2 End of Life Alert
When filter remaining capacity reaches 0 gallon (liter) or filter remaining time reaches 0 day, the
buzzer will beep twice and the digit will blink to notice user that the filter cartridge is in its end of
life, and out of function.
After change the filter cartridge, press RESET button. The DigiFlow 8000T will be reset to the
original filter remaining capacity and remaining elapse time value, and start monitoring filter again.
5.8.3 Low Battery Power Alert
When the battery power lower than normal working level, the buzzer will beep twice to notice and
the battery symbol on the screen will blink to notice user to change the battery. Once the batteries
are replaced, the alert will be released. The data will be kept in memory and stored back when user
replace the batteries.
