18
1) Disconnect from the power.
2) Remove the magnetic reduction plates
( 5) using the small recess and raise the
lift up as far as possible.
3) The space is now sufficient to chance
the router bit according to the instructions
of the router motor manufacturer.
Fig 6. Lifting the magnetic plate
10.1
Installing and changing router bits.
Fig
. 7
Router Bit Max Size
D max. 55 mm
10.
Operating the Router Motor
OFL3.0
Please observe the safety instructions in this manual before operation
NOTE
The tool change is made easier if you place the routing motor at a 45° inclination and lock
it. This gives you optimum access to the union nut and the collet.
4) Select the smallest possible reducing plate that suits the router bit diameter (5) and
insert it again. Always plan some space between reducing plate (5) and milling cutter
to ensure chip removal. Obtain the maximum cutter diameter per recess in the insert plate
you about the following graphics.
5) Make sure the router bit is firmly in the collet and does not collide with the reducing
plate
6) Make sure that the reducing plate sits flat and there is sre no chips or dust underneth.
!
WARNING
When selecting the router bit, observe the
maximum bit diameter permitted for the
particular router motor.
Important: In addition, the maximu
m
size
bit
that can be used with the OFL3.0 is
55mm
Ø
