SAUTER
flexotron®400 - RDT405
Display and encoder
P100012100
18
6
Display and encoder
All setting and configuration is done using the display and encoder.
The menu information on the display is organised in a tree fashion. Using the
encoder you can move between menus, set values etc.
In any of the configuration menus, a click on the encoder will activate change
mode. You can then rotate the encoder button to move between choices or set
values. A second click of the button will accept the choice.
The menu system is divided into two levels: The Basic level and the 10-second
level which contains all the configuration menus.
6.1 The Basic level
The Basic level comprises three sets of menu displays, the Base Display, the I/O
Displays and the Setpoint Display.
Base Display
This is an example of the Base Display, the display that is normally shown when
there is no operator activity.
The upper line shows which control mode has been configured, in this case
control mode 1,
T
emperature control. The bottom line shows the actual value of
the main input parameter.
There are bar-graphs showing the current output levels. In control mode 1 there
are symbols showing how the outputs have been configured (Heating, Cooling,
Damper or Change-over).
I/O
When the Base Display is shown, by twisting the knob counter clockwise until the
text I/O is displayed and then clicking on it, you can gain access to a menu where
you can look at the values and states of all inputs and outputs.
To exit this menu again, click on the knob and then twist the knob clockwise and
you will be returned to the Base display.
Setpoint
When in the Base Display, a click on the encoder button gives direct access to
the Setpoint menu.
See chapter 7 Setpoint.
