© Fr. Sauter AG
Im Surinam 55
CH-4016 Basel
Tel. +41 61 - 695 55 55
Fax +41 61 - 695 55 10
www.sauter-controls.com
[email protected]
Pr
inted in Switz
er
land
Subject to changes
6/6
P100001472 A
Change setpoint for normal domestic water
4.9
temperature ( )
1.
1
x
Move lower rotary switch to
; the setpoint
appears.
2.
Press the input knob; the setpoint fl ashes.
3.
Turn the input knob; change setpoint
4.
Press the input knob; confi rm new value
Change setpoint for increased domestic hot
4.10
water temperature ( )
1
x
Move rotary switch to
; the setpoint
appears.
For further steps, see 4.9.
Weekly switching programme for domestic
4.11
water
The weekly switching programme repeats itself every week. It consists
of a maximum of 48 switching commands. The switching commands
are captive. There are three possible operating statuses for domestic
water heating, with the following symbols:
STOP
no domestic water heating
START
normal temperature for domestic water
START
increased temperature for domestic water
Notes on the weekly switching programme:
A switching command can be valid daily (1-7) or on a particular day
•
(Mon, Tue, etc.).
If there is a switching command on a particular day of the week
•
(Mon, Tue, etc.), the daily switching command (1-7) is not valid on
that day.
If you want domestic water heating to operate always in normal
•
mode, there must be at least one switching command that invokes
the normal domestic water temperature.
START daily 0:00 hours
Call up weekly switching programme
4.11.1
(domestic water
)
1.
1
x
Set lower rotary knob to
2.
Turn input knob; select day of week
(1=Monday, 2=Tuesday, ...,1 - 7 daily)
3.
Press the input knob; the fi rst switching
command is shown.
View switching commands
4.11.2
Turn the input knob; each switching
command is shown.
An empty switching command is shown as
‹_ _ _ _›
Enter switching commands
4.11.3
1.
Turn the input knob until the next empty
switching command appears.
2.
Press the input knob; new switching
command is shown.
3.
Turn the input knob; time for the switching
command is changed.
4.
Press the input knob; time for the switching
command is confi rmed.
5.
Turn the input knob; select mode for the
switching command.
6.
Press the input knob; operating mode is
confi rmed.
Change/delete switching command
4.11.4
View the switching command as described in the section entitled
‚View switching commands‘, e.g.
1.
Press input knob; the switching command
is called up
2.
Turn the input knob; select whether to
delete (Clr) or change (SEt) the switching
command
3.
Press input knob; the selection is
confi rmed. If the switching command was
deleted, the next switching command will
be shown.
4.
To make a change, proceed as described
in the section entitled 'Enter switching
command'.
5.
And so on.
Return to automatic mode
4.11.5
1 x
Set rotary switch to ‹Automatic mode as
per switching programme›
Switching programme for pilot clock
4.12
1
x
Set lower rotary switch to
For further steps, see D11.
One-off water tank charge
4.13
1.
1
x
Set bottom rotary switch to
2.
Press the input knob to start charging the
tank
