Saunum H-1/6, Инструкция по использованию и установке

Страница: 11 / 25

11
Noises are coming from the sauna climate device.
• There is always a certain sound when the fan is running. If it is not smooth and/or has a metallic rumble, the fan will probably need service or repair.
Check the fan’s air vents for foreign objects. Try switching the fan to a lower speed.
• Accidental bangs are probably caused by the stones cracking in heat.
• Thermal expansion of parts of the heater may cause noises as the heater heats up.
1.6. Stacking of heater stones
Stacking of the stones has a major impact on the proper operation of the heater.
Important to know:
• The stones should be 5–8 cm in diameter.
• Use only heater stones intended for use in heaters. Suitable stone types are peridotite, olivinedolerite, and olivine.
• Lightweight, porous ceramic ‘stones’ should not be used in the heater. They do not store enough heat when heated and, as a result,
the heating elements may be damaged.
• Wash dust off the stones before putting them in the heater.
Note the following when installing stones:
• Do not let the stones fall into the heater.
• Do not force the stones between the heating elements.
• Do not let the stones rest on the heater elements, but put them so that they support each other.
• Do not stack stones on the heater.
• Do not place any objects that may alter the amount or direction of the air flowing through the sauna climate device near the stone room or the fan.
1.7. Maintenance
Due to the large temperature fluctuations, the heater stones tend to crumble. The stones should be restacked at least once a year or even more frequently if the
sauna is in active use. At the same time, stone fragments must be removed from the bottom of the heater and broken stones replaced with new ones.
This enables the heater to provide optimal heating and the risk of overheating is avoided. When using Himalayan salt balls in combination with a sauna climate
device, it is advisable to check the salt balls once a year and replace the worn and broken ones. Make sure that there are no foreign objects in the fan air vents of the
sauna climate device. The device should not be cleaned by children.
CAUTION! Before maintaining or cleaning the sauna climate device, disconnect the device from the power supply and wait for the moving parts of the device to
stop completely.
Before maintaining and cleaning the sauna climate device, make sure that:
• the sauna climate device is disconnected from the power supply (in addition to the power switch on the device, also by overcurrent fuses).
• the device’s fan has stopped completely.
• required work safety and personal protective equipment is used during the work.
• the connection cables are undamaged. If damage to the connecting cables occurs, the cables must be replaced by a qualified electrician in accordance with
applicable standards and regulations before going on with maintenance and cleaning work.