Step 3
å
Place a short edge of the BASE (W) against the RIGHT END (A) so
the bottom edge is even with the bottom edge of the RIGHT END.
å
Slide the RIGHT END MOLDING (U) onto the notched edge of the
RIGHT END (A) until it is against the BASE (W). Slide the LEFT END
MOLDING (V) onto the notched edge of the LEFT END (B), and
then slide the LEFT UPRIGHT MOLDING (X) onto the notched edge
of the LEFT UPRIGHT (D) as shown in the lower diagram.
å
NOTE: The MOLDINGS should overhang the inside surfaces of the
ENDS and UPRIGHT. If the MOLDING overhangs the wrong surface,
remove it and slide it on again.
å
Fasten an ANGLE BRACKET (LL) to the LEFT END (B). Use a BLACK
9/16" LARGE HEAD SCREW (WW).
å
*U.S. Patent No. 5,499,886
101730
www.sauder.com/services
Page 8
BLACK 9/16" LARGE HEAD SCREW
(1 used for the ANGLE BRACKET)
WW
LL
A
W
B
U
V
D
X
These edges should be even.
These edges should be even.
Sur
face
with
mor
e
holes
Sur
face with
TWIS
T-L
OCK®
FA
STENERS
Sur
face with
TWIS
T-L
OCK®
FA
STENERS
These edges must be even.
Slide the MOLDING (U)
against the BASE (W).
U
