å
Insert the METAL PIN (QQ) into the edge of the LEFT END (B). Only insert about 1/4 of the
PIN into the hole.
å
Fasten the LEFT END (B) to the TOP (G). Tighten two TWIST-LOCK® FASTENERS.
å
NOTE: Be sure the METAL PIN (QQ) inserts into the hole in the TOP.
å
Slide the LEFT END MOLDING (V) down to the bottom edge of the LEFT END.
å
Fasten the ANGLE BRACKET (LL) on the LEFT END (B) to the LEFT END MOLDING (V). Use
a BLACK 9/16" LARGE HEAD SCREW (WW).
å
NOTE: There is no pre-drilled hole in the LEFT END MOLDING (V). The SCREW will tighten
into the groove.
Step 8
101730
www.sauder.com/services
Page 13
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
WW
G
V
B
LL
Sur
face with
TWIS
T-L
OCK®
FA
STENERS
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
