SATO TH2 Series, Руководство оператора

Страница: 18 / 160

Section 2: Installation
Page 2-4 TH2 Series Operator Manual
2.3 LOADING MEDIA (cont’d)
4.
After pulling out the media, pass the media through the
media guides and place the leading edge of the media
on top of the platen roller .
Note:
Make sure the printed side of the media is facing
upwards.
5.
Close the top cover until it snaps into position.
Notes:
• Be careful not to get your fingers pinched while
closing the top cover.
• To load the media in the dispenser , please refer to
Section 2.3.2 To route the label when using the
dispenser
, for further instructions.
6.
After loading the media, press power button if printer
is turned off. If printer is on, press C button to clear
Cover open error.
When the printer is ready, press the pause/ feed button
to output the leading part of the media.
Caution
• When replacing media, bear in mind that the print head and its surrounding area remain hot.
Keep your fingers away from these areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
Media guides
Printed side should face
upwards
power button