SATO CS-9018, Руководство оператора

Страница: 37 / 62

3: J
OB
S
ETUP
pn 9386295-01 37
3.3.6.1. Example Of Cut Length and Paper Load Offset Setup:
The following is an example of a typical setup when the chip (the perf and a small amount
of form on either side of the perf) is to be removed. If chip removal is not desired it is only
necessary to program in “CUT LENGTH 01” for the length of the ticket.
NOTE: THERE IS NO CUT LENGTH 05 IN THIS
EXAMPLE. AFTER THE CHIP THE CYCLE
STARTS OVER WITH CUT LENGTH 01.
NOTE: PAPER LOAD OFFSET AT THE
START OF FORM IS SET TO ½ THE
WIDTH OF THE CHIP TO BE REMOVED
(IN THIS EXAMPLE “CUT LENGTH 04”).
CUT LENGTH
01
3 1/4”
03+ 24
CUT LENGTH
02
3 1/4”
03+ 24
CUT LENGTH
03
3 1/4”
03+ 24
CUT LENGTH
01
3 1/4”
03+ 24
CUT LENGTH
02
3 1/4”
03+ 24
START OF FORM
PAPER LOAD OFFSET
1/8” OR 00+ 12
CUT LENGTH 04
1/4” OR 00+ 24
PERF
CUT LINE