SATO CS-9018, Руководство оператора

Страница: 26 / 62

CS-9018 O
PERATOR
’
S
G
UIDE
CS-9018 Operator’s Guide 26
2.7. R
ESTARTING AFTER A
“
NO USE
”
SHUT DOWN
The CS-9018 is equipped with a time-lapse monitor and will shut down when not being
used. If one minute passes without the knife operating, the vacuum and motors will shut
down. If a time-out occurs and you want to start a job:
•
Press to restart the motors.
•
Press or again to resume processing.
2.8. E
ND OF FORMS
At the end of the forms, the cutter stops and “END of FORMS“ is displayed on the screen.
2.9. I
F YOUR UNIT HAS LOOP CONTROL
Loop Control is an option that is used to coordinate the flow of forms from a form feeding
device, such as a printer, to the CS-9018. Without this device, matching the speeds of the
two machines would be nearly impossible. There are no physical connections between the
two machines with this option.
When the paper clears the optional loop control sensor (located in the slot on the front of
the CS-9018) the CS-9018 will pause and <NoLoop> will be displayed beside the Job
Number on the display. When the machine feeding the forms catches up, the CS-9018 will
automatically start processing again.
Loop Control Sensor