SATO KEIRYOKI SK-1110, Инструкция по эксплуатации

Страница: 7 / 16

5
Fitting the vinyl cover over the unit
The SK-1110 comes with a vinyl cover that fits on the unit. With the cover in place, the
thermometer can be used even when your hands are wet. The cover also keeps the unit
clean and dry.
Cautions
 SK-1110 is not waterproof. Do not place it in water or use it where it may be splashed
with water. Otherwise, it will fail.
 If water enters the vinyl cover, immediately turn off the unit. Make sure that no water
enters the cover while the unit is being used.
 The measurement readings may become unstable if static electricity builds up inside the
vinyl cover while in use. If this happens, remove the vinyl cover and use the unit without it.
(1) Insert the unit fully into the cover, aligning
the display of the unit and (A) of the figure on
the right.
(2) Bend the (B) and (C) flaps to the unit side.
(3) Fold back the (A) part so that the cover
wraps around the upper and rear of the unit.
Releasing the Automatic Power-off
The SK-1110 is automatically turned off if no key is pressed for
30 minutes. Before conducting continuous measurement, release
the Auto Power-off function.
The mark P remains lit while the Auto Power-off function is activated.

How to release
Make sure the power is off. Press the PWR key once while
pressing down the HOLD key and release the HOLD key when
the OFF display appears.
The mark P goes out when the Auto Power-off function is released.
Caution
The Auto Power-off function release is disabled once the unit is turned off.
The Auto Power-off function should be released each time as necessary.