4
5-2. Connecting the Sensor Probe
1. Mach concavity
(
凸
)
of the plug of probe and
convexity(
凹
) of the socket of unit together and insert the
plug into the socket.
2. Turn the nut clockwise to fasten tightly.
3. To remove the probe, turn the nut counterclockwise to
loosen and pull the probe straight toward you.
5-3. Installation
Pull out two hooks for mount that are on back. Install the main unit on the wall with two
hooks. Be sure to secure them so that the unit will not fall down.
6. How to measure temperature
(1) After pressing the ON/OFF key to turn the power on, all characters are displayed for 3 sec.
Then the current temperature will be displayed and it enters the measurement mode.
(2) Insert the sensor stem into the object to be measured and read the temperature value after
the indication becomes stable.
(3) Press the ON/OFF key again and the display will disappear and power will be off.
7. Error Message
Display
Causes
Remedy
E02
Probe is not connected
Measured value is lower than -10.0
℃
Connect the probe.
Bring the value within the measuring
range.
If the error message is still displayed
stop using it and contact us or the
dealer.
E03
Connection of probe is insufficient
Short circuit occurs
Measured value is higher than 110.0
℃
E31
Abnormality may occur inside the
electronic circuit.
Stop using it and contact us or the
dealer.
•
凹
凸
